Basler L304kc Uživatelský manuál stáhnout pdf (Strana 41)

Operation and Features

Basler L304kc 3-7

Draft

Exposure End Delay

When an exposure is triggered by the ExSync signal, the actual end of exposure will be delayed.

(This is commonly referred to as an exposure end delay.) The exposure end delay includes two

components: the transfer gate time and the setup time. These times vary depending on the

exposure mode you are using. Table 3-2 shows the transfer gate time and the setup time for each

exposure mode.

For a given exposure mode:

End Delay = Transfer Gate Time + Setup Time

Exposure Mode Transfer Gate Time Setup Time

Level-controlled 1.40 µs

≤ 0.4 µs

Programmable

0.0 µs

≤ 0.4 µs

Edge-controlled 1.40 µs

≤ 0.4 µs

Table 3-2: Exposure End Delay Components

If you have the Dark Noise Cancellation feature enabled, the start delay and the

end delay will be different from what is shown here. See Section 3.10.2 for more

information.

The actual start and end of exposure can be monitored by using the Integrate En-

abled signal (see Section 3.4).

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 179 180

Žádné komentáře

Basler L304kc Uživatelský manuál Strana 41